Adjustment Clip + Fusion Problem (possible)

Hi everyone!
So, I have some problem. May be something wrong.
I take Adjustment Clip over main track. Make it 12 frames long. And then, press shift+5 and make simple transition:
1. Use Transform node, animate Center.X position and change Edge parameters to Mirror (3 keyaframes: 0.5, -0.5, -1.5)
2. Use Directional Blur node and animate Length parameter (3 key frame from 0 to max and back)
So, after that I return to Edit Page (shift+4), rename Adjustment Clip from Inspector to Whipe left and drag it to Media Pool. Than, if I take it from Media Pool to other place on Timeline it doesn't work properly. And it have two variation of «bad working»: nothing happened (all nodes and animation present (if we go to Fusion Page), but I have no animation when hit Play button) or I have some frames (on start or end on Adjustment Clips) from place where I started make this transition.

But if I use copy-paste Adjustment Clip on Timeline — it work. Problem only if I take it from Media Pool again.

So, what I do wrong?

HP z820, 2xE5-2687w, 64 gB RAM, AMD FirePro W8000

Are your keyframes in the new range of interest?


By the way... How is z820 dealing with resolve, and fusion? Is it viable?


Sent from my FIG-LX1 using Tapatalk

Are your keyframes in the new range of interest?

Sent from my FIG-LX1 using Tapatalk

Sorry, I didn't understand your question... Keyframes on Adjustment Clip and (as I know) they are didn't linked to global timeline (because there are on Adjustment Clip certainly)
And if I copy-paste (with Alt) Adjustment Clip on Timeline, it work perfectly. Problem only with same clip drag from Media Pool

Are your keyframes in the new range of interest?

Sent from my FIG-LX1 using Tapatalk

Sorry, I didn't understand your question... Keyframes on Adjustment Clip and (as I know) they are didn't linked to global timeline (because there are on Adjustment Clip certainly)
And if I copy-paste (with Alt) Adjustment Clip on Timeline, it work perfectly. Problem only with same clip drag from Media Pool

I guess this would be the case with a fusion comp...
But adjustment layer starts at 90000 frames if I am not mistaken... Worth checking though

Sent from my FIG-LX1 using Tapatalk

Check my reply on this thread
viewtopic.php?f=21&t=130415

Check my reply on this thread
viewtopic.php?f=21&t=130415

Thanks, try it. But its very strange behavior... Hope BMD someday fix this little thing

UPD. Yes, Its work! Thank you again!