Atem Mini Pro Recording to Hyperdeck Studio 2

I am trying to record the output of my atem mini pro to the Hyperdeck studio 2 via HDMI. When I set the hyperdeck to HDMI input, it shows no input. If I connect the output of my laptop directly to the input it recognizes the input. Is it because the signal is too weak? I read somewhere to try adding a HDMI splitter with EDID, that didn't help. Should I try something like a hdmi booster?

Based on the specs I can find, the Hyperdeck Studio 2 only supports common formats with the Mini Pro up to 30p (the Mini Pro can run up to 60p). Make sure the Mini Pro is running at a frame rate that is supported by the Hyperdeck you are using.

Yes, that worked. I switched it from 60p to 30p. Thank you

Hi

Is the onLyn way of connecting an Atem mini to the Hyperdeck 2 via hdmi?

I have an extreme iso and want to record the individual ISO’s. Can this be done over the Ethernet connection?