How to set ATEM Mini to DHCP

My mini seems to be working using a fixed IP but I would like to set it to DHCP but can't figure out how.

George

I don't recall anything about this from the manual.

I posted because several other posts suggested setting a Mini to DHCP to solve a problem but didn't say how. In the configure screen DHCP is not a choice that I could find while manual is.
I know the Pro defaults to DHCP.

George

Take a look in the Manual, pages 90 - 91.

OK, but I still don't see any reference to DHCP and the Mini (not Mini Pro).

Hi, I want to know if ATEM Mini doesn't have DHCP-Client. I didn't find a setting so the ATEM Mini will get IP by DHCP.

Best regards
Floh

The original ATEM Mini only supports using a static IP address, which is the same way all of the earlier ATEM models worked. The ATEM Mini Pro was the first ATEM model to support DHCP and this feature was also carried over to the ATEM Mini Extreme.

There is a note about these differences on pages 103-104 of the ATEM Mini manual:
https://documents.blackmagicdesign.com/ ... 3980810000

ATEM Mini connects to ATEM hardware panels and your network using a fixed IP address which
is set to a default address during manufacture. ATEM Mini Pro, ATEM Mini Extreme and ATEM
hardware panels can use a fixed IP address or DHCP.

Thank you! Didn't know the difference between the Mini and Mini Pro/Extreme in regard to DHCP-settings.